Consumer
Products
Philips AquaTrio Pro FC7088/61 3-in-1: vacuums, mops & dries Triple-Acceleration Technology Visible wet cleaning All hard floors with Triple-Acceleration Technology

Philips AquaTrio Pro FC7088/61 3-in-1: vacuums, mops & dries Triple-Acceleration Technology Visible wet cleaning All hard floors with Triple-Acceleration Technology

FC7088/61

Troubleshooting

How to flush my Philips AquaTrio Pro after use

We strongly advise you to flush the appliance after every use to prevent dirt from accumulating and bacteria from growing inside.

Note:

If you have flushed your appliance and it remains dirty, you can clean each part separately.

1. Switch off the appliance, place the appliance upright in parking position and pull the plug out of the wall socket

Parking position

2. Fill the clean water tank with water and empty the dirty water

Note: Make sure the clean water tank is filled and the dirty water tank is empty before you start flushing the appliance to prevent interruption of the flushing process. Interruption of the process has a negative effect on the flushing result.

Refilling/emptying water tanks

3. Fill a measuring cup with 300ml of water; Place the appliance on the flushing tray

Note: If you wish, you can add some liquid floor cleaner to the water.

Measuring cup

4. Pour the water slowly into the flushing tray; Make sure the water level does not exceed the MAX indication

Pouring water into the tray

5. Put the mains plug in the wall socket and switch on the appliance

Switching on the appliance

6. Let the appliance operate until the water in the flushing tray is used up; This takes approximately 15 seconds

Flushing the water

8. Open the mopping nozzle lid, remove the mopping brush cover and check if the inside is clean; Rinse the flushing tray under running water after flushing

Opening the mopping nozzle lid

The information on this page applies to the following models: FC7088/61 .

Not what you are looking for?

Did we answer your question?

If not, contact us.